[Constant Temperature and Humidity Test Chamber] The root cause of compressor overload burning

Source:

Release date: 2020-03-14

 Constant temperature and humidity test chamberIt is used to test the credible performance of industrial products at high temperature, low temperature and damp heat. For electronic and electrical, cars and motorcycles, aerospace, vulcanized rubber, plastics, metal materials, ship weapons, colleges and universities, scientific research institutions and other related commodity parts and raw materials in the high temperature, low temperature, damp heat transition conditions, test its various performance parameters. The refrigeration unit selected by the cryogenic system software of Wuhan Shang Test Experimental Equipment Co., Ltd. is an imported Dutch Taikang brand compressor. The safety protector of the compressor has over-temperature maintenance, over-voltage protection and over-current protection.

In the application of the whole process, some customers reflect the refrigeration unit current flow is too large, then, what is the cause of the compressor current flow is too large:
 
1. The working voltage of the switching power supply entered is too low, which is less than the working voltage value in the allowable work, resulting in excessive starting current.
 
2, compressor inter-turn short circuit fault, but did not achieve the level of burning out the insurance tube.
 
3. The "secondary friction" of the compressor destroys the smoothness of the friction surface, resulting in the expansion of the output power and current of the compressor, but it does not "hold the shaft" or "jam the cylinder", causing the electric type to fail to reach the rated value. The speed ratio makes the compressor unable to rotate, resulting in excessive starting current.
 
4. The refrigeration unit is affected by external factors. For example, the cooler is close to the wall, and there are too many stains on the pipe. Of course, the actual effect of the gas junction is poor, and the warm air cannot be released.
 
5, suddenly power off, and suddenly dial the phone, the time interval is short, in the system software in the height of the working pressure is not balanced, resulting in starting difficult, current flow is too large.
 
6. The refrigerant in the compressor leaks, the temperature cannot be reduced, and the motor runs continuously, resulting in excessive current.
 
7. The starting relay fails and the overload protector loses its working ability, resulting in excessive current flow.
 
In case of overload and power tripping of the compressor of the constant temperature and humidity test chamber, it is recommended to simply remove the common faults first: use a digital multimeter to check the ground resistance of the compressor motor, which should normally be around 2MΩ. If it is obviously reduced or close to zero, it indicates a short circuit fault. If the ground resistance is normal, check the resistance of starting and operating winding. Such as inter-turn short circuit fault, the operation of the current flow expansion.