Three Functional Analysis of Sand and Dust Test Chamber

Source:

Release date: 2019-04-24

sand dustTest chambersuitableUsed to test the enclosure sealing performance of the product, mainly used for the enclosure protection level specified in the standard.IP5XandIP6XTwo levels of testing. It mainly simulates the damage caused by sandstorm weather to locks, automobile and motorcycle parts, seals, power meters and other products.

blowing dust

  For research equipment on blowing dust(≤149μm)The adaptive capacity of the role. Test temperature: from high temperature test(GJB 150.3A)The operating high temperature or storage high temperature obtained by the temperature response of the pilot test piece;Humidity ≤30%.

 blowing sand

  For research equipment on blowing sand(150μm~850μm)The adaptive capacity of the role. Test temperature: from high temperature test(GJB 150.3A)The operating high temperature or storage high temperature obtained by the temperature response of the pilot test piece;Humidity ≤30%.

 dust fall

  Used to study covered or enclosed areas where there is little air flow and dust can accumulate for a long time.(Such as: office, laboratory, storage room and tent)Medium, dust fall(≤105μm)to equipment(Usually electrical equipment.)The impact. Dust fall can also affect the heat dissipation of equipment with accumulated dust on the top surface. The dust reduction test is also used to check the quality of the air filter at the inlet of the air pollution sampler used outdoors. Test temperature:23℃ ±2C. Humidity ≤30%.